Leased Industrial Property (NC002916)

1981 / 1996
1981 with an addition in 1996

Excellent

13,000 SF
Approximately 13,500 square feet on first floor, including a reception area, private offices, open administrative areas, restrooms and first-aid room. Finish consists of painted gypsum wall partitions, dropped acoustical ceiling tiles, recessed fluorescent lighting and carpeted and tiled floors. There is approximately 7,680 square feet of partially finished second floor offices.

460'2" x 527'2"/263'x179'

Min: 24', Max: 26' 6"

24’2” clear below the main beams in warehouse/former weave room

24’ clear below the main beams at the end wall to 26’6” clear below the main beams at the center in the former slashing area

38' x 45'

10” steel H in manufacturing area previously used for slashing and 8” square steel in manufacturing area formerly used for weaving

Steel H

Heat-welded Stevens Roofing Systems, single-ply membrane roof installed in 2005 with a transferable 15-year warranty that is effective until March 10, 2020

6" Reinforced Concrete - 6” concrete floor slabs at 3,000 psi reinforced with 6x6x10/10 welded wire mesh in 242,588 square feet once used as a weave room. All floor openings for sub-floor air returns have been capped with metal plates to accommodate a previous warehousing tenant. There is a 6” non-reinforced concrete floor slab at 4,000 psi over 4” compacted stone based in the manufacturing area previously used for a slashing operation.

The south, west and east walls are 6” insulated pre-cast concrete panels. The north (rear) wall is an expansion wall consisting of painted un-insulated concrete block.

High pressure sodium vapor 250 wall fixtures in the production area formerly housing slashing, the balance of the plant area has 400-watt, high bay metal halide fixtures (22 foot-candles)

West-Canopy-covered w/8'x12’ DI, 12’x12’ DH electric r/u w/seals, pads & auto leveler
8’x9’ DH electric r/u w/seals, pads & auto leveler
8’x12’ DH electric r/u w/lock, above flr level & ramped, prev accommodate beam loading sys in whse
10’x12’ DH electric r/u above flr level & ramped to accommodate beam loading sys in whse
East-2-8’x9’ DH electric r/u w/seals, pads, spotlights, locks & auto levelers
8’x8’ DH
North-8’x8’ DH
South-6–8’x10’ DH dock plates, seals, pads & "Dok-Loks"

2-2 ton overhead bridge cranes that are pendant-operated, with approximately 15’ underhook height

Approximately 300 paved, marked and lighted spaces with limited access security fencing and a gate guard security station

No

North Carolina Natural Gas Co, 4" main, 4" line

City

City - Provided by Harnett County Public Utilities with 1,200,000 gallons per day maximum capacity at the treatment plant, on-site lift station and 8” force main to transport waste to the treatment plant

CP& L/Progress Energy
Supplied by Carolina Power and Light/Progress Energy
13,200 volt primary service
4 – 4,000 amps, 480Y/277 volt, 3 phase, 4 wire distribution switchgear for production equipment and lighting
1 – 1,500/1,680 KVA, 4,160 volt switchgear serves 2 chillers
1 – 3,000 KVA, 4,160 volt switchgear serviced the compressors (compressors have been removed)

Electric
The finished office area has electric rooftop package heat pumps providing heating and air conditioning (5 units totaling 37.5 tons). The production areas were previously heated by steam boilers; however, those boilers have been removed.

No - The finished office area has electric roof-top package heat pumps providing heating and air conditioning (5 units totaling 37.5 tons). The plant was previously operated with process refrigeration and humidity control. Although not operational, 2 – 700 ton 1982 Trane Centrivac chillers remain onsite along with a Marley cooling tower. 10 – 110,000 cfm Bahnson air washers remain as well.

Yes - 100% wet system with one dry valve unit. This is an 8” closed loop system that is fed by a 300,000 gallon, onsite, above ground water storage tank with a Cummins 187 hp, 3,300 rpm, 1,500 gpm diesel-fired pump with an electric jockey pump.

12 circulation fans and 1 Greenheck roof top centrifugal fan in the warehouse area (former weave area)

All compressors have been removed. All air line distribution remains throughout the plant.

Mfg: 460'2" x 527'2" and 263’ x 179’
Addition: 60’6” x 148’8” less 15’10-1/2” x 22’
Partially Finished Office: 120’ x 64'

Mfg: 242,588 sf of production & support area originally used for textile weaving and most recently converted to warehousing; 47,077 sf which includes the main office area & mfg area previously used for a slashing operation
1996 Add: 8,643 square feet
Office: 7,680 sf on second-story partially finished office
Misc: Not included in the total square footage is a 4,400 sf boiler house, an 808 square foot pump house and a 160 sf guardhouse

Textile - Warehousing/distribution and textile weaving